- 🔧 A Cost-Effective and Rapid Assortment for Securing Wires, Tubes, Hoses, or Rods Ranging from 1/4″ to 1″ Diameter to Metal, Plastic or Any Other Surface Ranging from 1/32″ to 1/8″ Thickness. They Snap into 1/4″ Diameter Holes and are Held Firmly in Place.
- ✅ Durable Construction – These Clips are Made from Quality Nylon Materials to Ensure Reliable Performance and Long Service Life. These Are Reliable Replacement for the Original Part That had Missing or Failed Due to Fatigue.
- 🚗 Fits GM Ford Chrysler Models, Including Routing Clips, Wire Loom Routing Clips, Releasable cable strap, Cable Tie, Tape-On Bundling Clip, Push Mount Cable Tie.
- ✉ Clip Size: 1🌴 Tube / Hose / Wire Outside Diameter: 1/4″, 2🌴 Tube / Hose / Wire Outside Diameter: 3/8″, 3🌴 Tube / Hose / Wire Outside Diameter: 1/2″, 4🌴 Tube / Hose / Wire Outside Diameter: 5/8″, 5🌴 Tube / Hose / Wire Outside Diameter: 3/4″, 6🌴GM 12040984 I.D. 1/4″, O.D. 3/8″, 7🌴GM 8911473 I.D. 11/32″, O.D. 1/2″, 8🌴GM 8911497 I.D. 13/32″, O.D. 19/32″, 9🌴GM 8911472 I.D. 1/2″, O.D. 11/16″, 10🌴GM 8917320, 3816659, 19130464 I.D. 3/4″, O.D. 1″.
- ☺ Please Check the Part Number and Installation Position Information on the Picture Before Purchase.


Frete Grátis em todo o BrasilProduto Original Importado dos EUA
OAUTOO 190pcs Wire Loom Routing Clips Push Mount Cable Tie Assortment
*$529.00
Informação adicional
Size | One Size |
---|---|
Material | Nylon |
Brand | OAUTOO |
Fastener Type | Push |
Head Style | Push |
Tyler –
Great product price was reasonable
TB –
This is a very good kit representing a good cross section of plastic fasteners that need replacement
Larry W. –
Great selection of wire clamps for multiple applications
Mike hitchcock –
Good kit worse great for my application.
Leon Crowley –
Like them and they help out
kurt gardner –
O
James from SC –
Help secure the wire loom in place.
I Review –
I’m in the midst of doing some general clean up of the old hot rod’s wiring. Over time these clips have a tendency of getting brittle and breaking. I bought this variety pack with the hope that I could have various sizes on hand to meet my need. I think that it’s a decent little set at not a terrible price. One thing that would be extremely nice is if they published the size of the attachment points. Probably not terribly difficult to figure out through a little trial and error or comparing drill bits — I haven’t yet drilled any holes to push these through, just have used existing holes as mounting points.