Frete Grátis em todos os produtos
- This is the Black Square 4-pin plug used on most LS applications
- These oxygen sensor 24″ harness will make for an easy installation and will avoid the problems of faulty O2 sensor readings that are common with cutting and splicing.
- This package contains a pair
- This package includes two 24″ oxygen sensor harness cable for LS1 engines
- LS1 02 Oxygen Sensor Header Harness 24″ 4-pin, Fitment for LS Camaro Firebird Pontiac Chevy Applications
O2 Oxygen Sensor Compatible for Toyota 4Runner, Corolla, FJ Cruiser, Highlander, Land Cruiser, Matrix, Prius, Yaris & for Lexus ES350, GS350, GS450h, IS250, IS350, NX200t & for...
*$699.00
Denso 234-4168 Downstream Oxygen Sensor with 4-Wire 13.7” Harness
*$909.30
Frete Grátis em todo o BrasilProduto Original Importado dos EUA
Michigan Motorsports Oxygen Sensor 24″ Harness 4 pin Fitment for LS LS1 Camaro Firebird Pontiac Chevy Application
*$397.00
Informação adicional
| Brand | Michigan Motorsports |
|---|---|
| Mounting Type | Flange Mount |
| Output Type | Analog |
| Sensing Distance | 24 Inches |
| Specific Uses For Product | Oxygen Sensor |
Chris –
Quality is nice, it did not fit my square style of connector with out some mods. The mods were easy to make, which if you do make these mods instead of returning, you will be happy with this product.
Michael m. –
I needed an extension for the passenger side O2 sensor on my 2008 Trailblazer SS…this fits great and is long enough to zip tie away from any heat or vibration.
Michael m. –
I purchased a new oxygen sensor because I had a code for a bad sensor, and to clean things up I bought these extensions because I have headers. Long story short after a month of going on a wild goose chase I found two wires not in the correct spot in the connector on each end. Talked about pist off. I couldn’t drive my car for over a month
Brandie –
Not their fault this did not fit my vehicle was hoping it would work for my Pontiac G8 it did not. Very similar except for the oem 02 inside has a small little tab on both sides this has one. Ended up splicing and using the extra wiring.
Scott –
Fit perfectly on my 2008 TBSS. Even though these say they fit an LS1, these worked on my LS2 motor. The black plugs and keyway tabs inside matched perfectly with the black connectors on my O2 sensors. Everything looks and feels well made. Only gripe is I wish these came in shorter lengths, only needed 6″.
Eric –
Although longer than needed, these are answering the mail to my need.
Dean H. –
I needed these for my 98 Camaro Z28 after I installed my new headers. I tried a 6 inch extender but it wasn’t long enough. These worked just fine.
John hutto –
I don’t drive it daily but I don’t have any oxygen sensor codes. Seemed like good quality.