- WATERPROOF & STURDY: The heavy duty cut off switch is made of ABS plastic housing and copper tin plating inner stud. Fully enclosed design to protect wiring from dirt, corrosion, and rain.
- SAFETY PROTECTION: This battery on off switch can isolate and secure the electrical system; eliminate any power draw from the battery when vehicle is not in use, disconnects the battery safely; provide a reliable way to shutdown electrical power during maintenance and protect batteries from excessive drain
- ROTATE BUTTON FOR EASY OPERATION: On/Off 2 position, Suitable for various 12V 24V 36V 48V systems. Rating: 275A DC Continuous (1hr), 455A DC Intermittent (5 min), 1250A DC Cranking (10 sec). Clockwise to turn on , counter clockwise to turn off
- WIDE APPLICATION: This master battery shut off switch is universal used for RV, Marine, Car, Boat, Camper, Travel Trailer, Truck, ATV, UTV battery and other engine application, makes it an effortless job of turning the battery on and off
- PACKAGE INCLUDE: Equiped with 1* Battery Switch, 4 Pcs Mounting Bolts, 4 Pcs 2*3/8 Copper Ring Terminals, 4 Pcs Heat Shrink Tubings and a hex wrench, which can provide great convenience for your installation.


Frete Grátis em todo o BrasilProduto Original Importado dos EUA
Battery Disconnect Switch 12V-48V DC 275A Battery Power Master Isolator Shut Off Switch for Marine Boat Car Truck Camper RV Trailer
*$301.00
Informação adicional
Operation Mode | ON-OFF |
---|---|
Current Rating | 275 Amps |
Operating Voltage | 48 Volts |
Contact Type | Normally Open |
Connector Type | Screw |
Brand | GOGONFLY |
Terminal | Marine |
Item dimensions L x W x H | 2.67 x 2.67 x 2.8 inches |
Circuit Type | 1-way |
Mounting Type | Panel Mount |
Switch Type Kill Switch | Switch Type Kill Switch |
fishingmike22 –
Good quality worked perfect
Texas Roy –
Works as advertised. Simple installation.
Don H –
Was exactly what I needed
Sunny –
I had a short in the wiring on my KZ trailer, as you can see in the photos it melted the wiring and the battery cutoff switch.
This was a direct replacement for the OEM battery cutoff switch and even fit into the existing mounting holes.
Works perfectly.
Steven M. –
Simple and effective battery isolation
JR –
My old one was shorting out. This will l once works well. I’ve used it for a few months in saltwater. It is not super high quality but it’s holding up
Antoine –
I put that on my old alpine 2 snowmobile to get power or not from the battery to the winch and ignition or not
Easy to install came with everything you need. 👠you can wire this thing from every side! Just remove the panel from where you want your wire to came in! Well built easy to turn on or off.
David Mohler –
Easy to install easy to use.
denise –
I used it for a cut off switch on my RV. It was easy to install and is performing well.
Johnny Nui –
very good, not perfect but does the job well