- GM-recommended replacement part for your GM vehicle’s original factory component
- Offering the quality, reliability, and durability of GM OE
- Manufactured to GM OE specification for fit, form, and function


Frete Grátis em todo o BrasilProduto Original Importado dos EUA
ACDelco GM Original Equipment 213-1579 Engine Crankshaft Position Sensor
*$692.10
Informação adicional
Brand | ACDelco |
---|---|
Item dimensions L x W x H | 3.9 x 2.5 x 1.1 inches |
Maximum Supply Voltage | 5 Volts (DC) |
Mounting Type | Flange Mount |
Output Type | electrical signal |
Specific Uses For Product | Crankshaft Position |
UPC | 021625768243 |
Global Trade Identification Number | 00021625768243, 30021625768244 |
Manufacturer | ACDelco |
Style | Modern |
Model | Crankshaft Position Sensor |
Item Weight | 1.13 ounces |
Product Dimensions | 3.9 x 2.5 x 1.1 inches |
Country of Origin | Japan |
Item model number | 213-1579 |
Exterior | Painted |
Manufacturer Part Number | 213-1579 |
OEM Part Number | 12575482 |
Date First Available | September 20, 2007 |
Amazon Customer –
as you know there are two of them upper and lower always replace both
M. Bazer –
Part went out in less than 1 year.
Kevin Helgeson –
Don’t go for any other than ACDelco if you want the right part for the right fix. A price is nothing for the quality, would recommend to anyone who needed it.
Josh –
Bought an aftermarket one originally which failed immediately. Based on advice, I purchased AC Delco and I have not had a single issue since installing it.
Scott A. –
Its in a Cadillac an d running great
Dennis M. Liput –
Perfect fit solved stalling problem
Troy V –
AC Delco OEM part, good price, great shipping, very happy. Was a little difficult to install, not the fault of the part, but the designer of the car. Allow about 1 hour or so to install. 2003 Oldsmobile Aurora 4.0 V8 Northstar motor. Block rear wheels, jack up car, place jack stands under engine cradle, lower car onto jack stands, remove lower front splash shield, remove brake line bracket from engine cradle, pull back brake lines for access, 10mm deep & shallow socket 1/4 inch ratchet, remove wiring harness by pushing in lock pin on clip & pull out wiring socket from lower CKPS, remove 10mm bolt, pry old CKPS from engine (should pop out relativity easy), apply engine oil to new CKSP seal & install new part & reverse removal order. Make sure to replace upper at the same time, if the one you are replacing is bad, the other probably isn’t far behind. Your arm may get a little cut up as you will be working in a small confined area, so be careful. The CKPS is located next to/behind the center motor mount (front) by the oil filter & oil pressure sensor. None of these items need removal to replace the CKPS. If you have a 1/4 swivel & a short 10mm socket, you may have a easier job replacing the sensor. There are some blogs that say the ECM may need a relearn procedure, but I didn’t do that & my car ran just fine. Good luck.
Amazon Customer –
Fixed check engine light on our 03 Cadillac DTS