Frete Grátis em todos os produtos
- Pack of 2. Fitting Diameter: 3/8″(9.5mm) hose barb weld on bung
- Material: Made of high performance lightweight 6061-T6 CNC machined billet aluminum
- MUST BE WELDED, designed with a recess step on weld end to make mounting flush to a surface easier
- Application: Can be used for most automotive needs, such as: Fuel, Oil, Coolant, Air, and more.
- Weld in bungs are most commonly used when needing to attach AN lines to areas that don’t currently have an AN flare. A few examples would be: Intercooler piping, Intake manifold, or even a custom overflow tank.
Hopkins Towing Solutions 20022 Endurance 7 Blade 3' Vehicle Side Jacketed Cable
*$682.10
1703-3305 Fuel Cap Replacement for Case International Tractor 1566 1568 Replaces # 23995DC 23995DA
*$283.40
Frete Grátis em todo o BrasilProduto Original Importado dos EUA
3/8″(9.5mm) Weld On Hose Barb Tail Nipple ON Bung Weldable Fitting Adaptor, Billet 6061 Aluminium, Pack of 2
*$322.50
Informação adicional
| Size | 3/8" BARB |
|---|---|
| Material | Aluminum |
| Brand | KRD PERFORMANCE |
| Color | Natural |
| Connector Type | Nipple |
| Thread Size | 0.375 inch |
| Number of Pieces | 2 |
| Manufacturer | KRD PERFORMANCE |
| Part Number | KWF38 |
| Item Weight | 0.16 ounces |
| Package Dimensions | 1 x 0.5 x 0.5 inches |
| Item model number | KWF38 |
| Batteries Included | No |
| Batteries Required | No |
| Date First Available | September 27, 2023 |
dan –
This is a barb. It’s weldable aluminum. Got it to use a bigger fuel line. Didn’t end up needing it. A little steep but you get two. Good find.
Jose –
Used this to fabricate a fuel tank. Can’t go wrong with this item. Well worth it.
Tim Bowsher –
Nice simple weld on barb. It is a sharp shark fin barb that will cut into the hose when you tighten it down, just plan for that. It is not the rounded barb for use with barrier hose. I’m going to try and round off the tip and convert into a bump.
Can’t go too far, the OD is only .600″, a loose fit for the 5/8 hose. You will need compressible hose and a clamp for this to seal.
Ron P. –
These barbs are well made and were easy enough to install. I used these on an intake for my turbo Miata and they went on about as easy as you’d expect. I really like that these have a step down, so you can drill a slightly smaller hole and have the barb sit in the tube fairly snug. After roughing up the edges a bit, these were easy to weld and seem to be made of quality aluminum.