- 【Product Features】The3/8″ Side Post Remote Battery Disconnect Switch is a 12V device that supports a 100 meter remote battery disconnect switch but can be left unused, not only preventing the battery from draining but also reducing the risk of theft. It is a very convenient remote control that disconnects the battery with a quick push of a button and without opening the hood. The remote control is pre-programmed for no additional operation and is rated at 200A continuous/1000A cranking current to start the unit even in cold weather.
- 【Product Specifications】Copper bridge with 3/8″ hole. Relay switch stud terminal size: 1/4″ (7mm) x 2. Rated for high current 200A continuous/1000A cranking, this switch (remote receiver) draws 0.001 – 0.005 AMPS when connected.
- 【Easy Installation】Installation instructions are included with the 3/8″ Side Post Remote Battery Disconnect Switch . The red and black wires in the X supply power to the remote receiver in the relay, NOTE: It needs to always be connected to the positive and negative battery terminals respectively. The stud terminal on one side of the relay connects to the negative terminal of the battery and the other side connects to the negative wire of the car.
- 【Wide Use】Farpida‘s Car battery disconnect switch comes with 1 wireless remote control, the remote control can be controlled within 100 meters, which can be widely used for cars, trucks, boats, RVs and travel trailers.
- 【Service】 At Farpida, we provide 7/24 response service. Low risk purchase is for every customer’s smile. If you have any quality problems with your product, please contact us and we will replace your parts with new ones for fr-ee.


Frete Grátis em todo o BrasilProduto Original Importado dos EUA
3/8″ Side Post Remote Battery Disconnect Switch 12V Remote Battery Disconnect Switch 12V Universal Fit Battery Kill Switch for Car Truck UTV ATV 200/1000 AMP Heavy Duty On/Off…
*$469.00
Informação adicional
Operation Mode | manual |
---|---|
Operating Voltage | 12 Volts |
Contact Type | Normally Open |
Connector Type | Stud |
Brand | Farpida |
Terminal | Stud |
Item dimensions L x W x H | 4 x 2 x 3 inches |
Circuit Type | 2-way |
Actuator Type | Push Button |
Contact Material | Brass |
Switch Type Kill Switch | Switch Type Kill Switch |
gdnite –
Have to enlarge the holes for bolts to fit battery and cable ends. Will see if it keeps battery from draining
Jesse Mendoza –
Just like it’s promoted
Works very well
Awesome product
Judith H. –
This does NOT fit side post batteries as is. You will have to drill out the connectors slightly to make it fit on your battery post. And get the right size bolt. Other than that, it works as it should so far.
Kurt Richard Murray –
This power interrupter is required for my GMC YUKON XL DENALI that sits idle for weeks at a time. The constant drain on the battery from all the computers is small amperage wise, but enough to reduce my available starting voltage below 12.5 V ! This product will isolate my battery from a constant slow drain that after 3 to 4 weeks causes it not to have enough starting voltage. Well made with HD components.